Ubiquiti NanoStation NSM2 (2.4GHz) Wireless Bridge & WiFi AP

Key Features

• Connect two remote locations on the one network

• Share Internet connection between buildings, remote sites, etc.

• Up to 600mW output power, 2x2 MIMO operation, 150Mbps

• Integrated AirOS web software for controlling power, bridge/AP mode, etc.

• Includes PoE injector and 240V AC adaptor

• Two units required for wireless bridge 

• High speed point-to-point networking.

Usage

• Forget Ethernet cable, the Ubiquiti NanoStation is ideal for bridging networks or sharing broadband across distance

• To install, place the units at either end of the network and connect both to Ethernet cables - for example, connect the first unit into your modem at location one, and connect the second into an Ethernet switch or WiFi access point at the other location

• Up to six remote buildings can be linked over one connection with the NanoBridge supporting AP-WDS.

• This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple - no routing configuration, all protocols (DHCP, DNS, etc) just work

• Management of the Ubiquiti device couldn't be easier with SSH and SNMP protocol support and an intuitive HTTP interface.

802.11b/g/n WiFi Access Point

• Login to the AirOS management software and set to AP mode to create a high performance, long range WiFi network

• With a wide directional broadcast angle the NanoStation M2 is ideal for covering sports grounds and outdoor areas with a sector-by-sector approach

• You can learn how to set up the NanoStation as a long range WiFi access point by following their Quick Start Installation Manual

Ready to Install

• This unit has all networking hardware integrated and is completely weatherproof for permanent installation in even the toughest environments

• Signal strength indicators allow for quick and easy alignment

• For best performance the unit should be roof mounted, high and clear of obstructions, via its integrated pole mounting bracket

• The units are powered via Power over Ethernet (PoE) - simply plug one end of the Ethernet cable into the NanoStation, and the other into the PoE Injector (which is plugged into AC power) - this allows one cable to power the unit and also carry network traffic

• We recommend using Cat6 Outdoor UV Shielded Cable with this unit.

A heads Up!

• Surge protection should be used for all outdoor installations. Ubiquiti recommend that you use two Ethernet Surge Protectors - model ETH-SP - place one near the NanoStation and the other at the entry point to the building

• The ETH-SP will absorb power surges and safely discharge them into the ground.

Read more

• Specification Sheet

• AirOS Complete User Guide

•  Ubiquiti Networks Case Studies

Setup Guides (click on image)

.