Quantity	Image	Name	Price
		TS9 to FME Male	$18.60 In stock
		TS9 to N Female	$18.60 In stock
		TS9 to SMA Female	$18.60 In stock
		TS9 to TNC Female	$18.60 In stock

Add Selected to Cart

Telstra Nighthawk Patch Lead (NETGEAR Nighthawk® M2)

Key Features

Next time you're out-and-about look around you - every day thousands of Australians use external antennas to enjoy fast, uninterrupted wireless broadband internet
If you're in a rural, hilly, low signal area, or you can't get a good signal indoors there's no need to tear your hair out over slow mobile broadband crashing or dropping out half way, when an external antenna is often all you need.

Most antenna cables terminate with a standard connection, most commonly a female 'FME' connector
To plug an antenna into your phone or wireless modem, you need a short cable that acts as a conversion from the FME connector to the device-specific connector that will plug into the antenna port on your device.

The modem's contacts are not recessed as with other models, so the TS9 Patch Lead does not sit flush against this modem
Although there is no audible 'click' when the patch lead is inserted, a good connection is still achieved, so there's no need to apply additional force, doing so may damage the connectors - then you'll be calling us again for a replacement!

The Telstra Nighthawk device uses a technology called MIMO along with Carrier Aggregation
This technology uses two antennas to theoretically double your speed in selected areas, and CA to combine several frequencies together to permit even higher data rates
To check whether your area is MIMO enabled or to learn more about the Telstra 4G network, use our Telstra coverage map guide
Outside the 4G network area, the modem will only use one radio and will require only one antenna connected. This antenna must be connected to Port-1 - you can find the port numbers written on the port covers.