Ubiquiti Bullet Dual-Band airMAX® AC Radio with Dedicated Wi-Fi Management

Key Features

Designed to streamline the complications of routing hardware, the Ubiquiti Bullet sits between the Ethernet cable from your network and a WiFi antenna
The revolutionary technology performs the physical layer changes necessary to transmit data directly from the Ethernet cable over the air via Dual Band Wireless to the receiving unit.

The Bullet features a tough weatherproof design
The durable casing of the Bullet AC can withstand nature’s harshest outdoor elements.
Featuring an upgraded aluminum casing, weatherproof N-Type connection gasket, and water-tight cable gland, the Bullet is virtually bullet-proof
The Ubiquiti Bullet eliminates the need to use RF cables and requires no special antenna or tools to install
No radio card/host board issues
No RF cable quality concerns
No mechanical stability concerns
No enclosure mounting requirements
With the Bullet operators can just plug and go
This is a transparent data-link layer bridge, not a routed bridge - this means that you are creating a virtual ethernet cable between the two facilities, making network setup incredibly simple - no routing configuration, all protocols (DHCP, DNS, etc) just work
Management of the Ubquiti device couldn't be easier with SSH and SNMP protocol support, as well as a very intuitive HTTP interface
The units are powered via Power over Ethernet (PoE) - simply plug one end of the Ethernet cable into the Bullet, and the other into the PoE Injector (which is plugged into AC power) (PoE not included)
This allows one cable to both power the unit and also carry network traffic
We recommend using Cat6 Outdoor UV Shielded Cable with this product.

Surge protection should be used for all outdoor installations. Ubiquiti recommend that you use two Ethernet Surge Protectors - model ETH‑SP- place one near the NanoStation and the other at the entry point to the building. The ETH‑SP will absorb power surges and safely discharge them into the ground.

(B-DB-AC)